Paver Stone Steps Diy

A diy stone paver patio tutorial step 1.

Paver stone steps diy.

Setting paver steps into a hillside is one way to turn a slope into a usable walkway that is both attractive and convenient. Lay down a layer of landscape fabric to cover the excavated area. Next add a layer of landscaping fabric on top of the dirt. Check the sand height against the top step by laying a paver on it.

How to build steps out of stone pavers step 1. Using your excavator excavate to a depth of 9 inches image 2. Excavate 8 inches deep in the area in which the first step is installed. Then divide the net size of each step by the size of your pavers to see how many you need.

Once you know these dimensions you can work out how many steps you will build. Mark the perimeter of the path using spray paint increasing the size by 6 inches for the over dig image 1. The width of the compacted area will. Start by digging out the area where you d like to place your stone paver patio.

Lay out the landscaping fabric. How to build a patio. It ll tamp down later. The over dig is necessary to make sure that the outside edges of the stone remain stable during and after the installation.

Take care not to step in the sand or compress it. This will aid in rainwater drainage under the. Ensure your steps all end up at the same height and that each step is 15 inches deep from front to back. Use sand to feather the slight slope in the gravel to meet the level steps evenly.

Stone or brick pavers require no mortar when properly set so the labor required to install them is considerably less than pouring concrete.