My Door Handle Won T Turn

Spray the door key with a graphite based lubricant.

My door handle won t turn.

One of the problems that causes this is that the hinges are loose or the house has settled from the freezing and thawing of the ground. Paint on the edge of the door sometimes prevents the barrel from retracting. Attempt to free the lock button by pushing on it. Don t use a wet.

Take knob handle off the door. Here are the general steps to remove the handle and lock from the door and test the retraction mechanism. It will come in two pieces. Push on the lock button and hold it in.

You can fix this problem relocating the hinges or using longer screws. 3 if this does not help remove the knob and check the spindle. The knob should turn freely. The lock button on the door knob is stuck the solution.

Twist the screwdriver to see if the mechanism engages properly. Use a tool a flathead screwdriver will work to twist within the gap the thru spindle inserts into. 2 hold the knob on the other side of the door and turn the loose knob clockwise until it fits snugly. Leave the striker bolt in place.

If the set screw on the handle is stripped and difficult to tighten replace it with a new one. To fix the door knob figure out where the connections have gone awry. Check to see that the door striker the spring loaded bolt that latches the door pushes in and springs back easily. If this is the problem clean the paint off.

Replace the handle and reinsert and tighten the retaining screws. Door gets stuck another problem with many door knobs latches and even hinges is that the door itself will get stuck and close or open hard. Flip the key and open the door. Remove the two screws one on either side of the handle and remove the knob.

Slide the key in the lock and tap lightly on the key to lubricate the inside of the lock. Remove the handle by taking out the retaining screws usually two located at the top and bottom of the inside handle. If simply pressing the lock button on the door knob doesn t free it turn the door knob while pressing the. Remove the thru spindle.

Place flat head screwdriver in the gap you removed the spindle from. Take the handles knobs off of the door. Then tighten the screw until you feel it resting against the flat side of the spindle. Step 3 turn the handle over and if necessary reverse the latch nose.